Routing Table Monitoring Commands - Huawei Quidway S3900 series Command Manual

Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
Chapter 1 Static Route Configuration Commands
Note:
When running a routing protocol, the Ethernet switch also functions as a router. The
words "router" and the router icons covered in the following text represent routers in
common sense and Ethernet switches running a routing protocol. To improve
readability, this will not be mentioned again in this manual.
This manual deals with the S3900-EI series switches. The ospf, ospf-ase, and
ospf-nssa commands are supported by the S3900-EI series, but not supported by any
other S3900 switch. This will not be mentioned again in this manual.

1.1 Routing Table Monitoring Commands

1.1.1 display ip routing-table
Syntax
display ip routing-table
View
Any view
Parameter
None
Description
Use the display ip routing-table command to display the routing table summary.
This command displays the summary of the routing table. Each line represents one
route, containing destination address/mask length, protocol, preference, cost, next hop,
and output interface.
This command displays only the currently used routes, that is, the optimal routes.
Example
# Display the summary of the current routing table.
<Quidway> display ip routing-table
Routing Table: public net
Huawei Technologies Proprietary
1-1
Chapter 1 Static Route Configuration
Commands