Auto-Build - Huawei Quidway S3900 series Command Manual

Command Manual – Cluster
Quidway S3100 Series Ethernet Switches-Release 1510
A cluster contains one (and only one) management device. After rebooting, a member
device identifies the management device by the MAC address of the management
device.
You are recommended to use the delete-member command to remove a cluster
member from a cluster on the management device.
Example
# Remove a member device from the cluster.
<aaa_1.Quidway> system-view
System View: return to User View with Ctrl+Z
[aaa_1.Quidway] cluster
[aaa_1.Quidway] undo administrator-address

1.3.3 auto-build

Syntax
auto-build [ recover ]
View
Cluster view
Parameter
recover: Establishes communication with all the member devices again.
Description
Use the auto-build command to build a cluster automatically.
This command can be executed on a candidate device or a management device.
When you use this command on a candidate device, you will be required to enter the
cluster name and build a cluster. Then the system will collect candidates and add the
collected candidates into the cluster automatically.
When you use this command on a management device, the system will collect
candidates directly and add them into the cluster automatically.
The recover keyword is used to recover a cluster. Using the auto-build recover
command, you can find the members that are not currently in the member list and add
them to the cluster again.
Note: Ensure that NTDP is enabled, because it is the basis of candidate and member
collection. The collection range is also decided through NTDP. You can use the hop
command in system view to modify the collection range.
Huawei Technologies Proprietary
1-17
Chapter 1 HGMPv2 Configuration Commands