Huawei Quidway S3900 series Command Manual page 492

Command Manual – Multicast Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
source-address: Source address of the (S, G) entry. If you do not specify a source
address, the system displays all source information of the specified group. If you
specify neither a group address nor a source address, the system displays all SA
caches.
autonomous-system-number: Number of the AS where the (S,G) entry comes from.
The value ranges from 1 to 65535.
Description
Use the display msdp sa-cache command to display (S, G) state learned from an
MSDP peer.
You must configure the cache-sa-enable command before the system can display the
cache state information.
Example
# Display SA messages learned from the MSDP peer.
<Quidway> display msdp sa-cache
MSDP Total Source-Active Cache - 5 entries
(Source, Group)
(10.10.1.2, 225.1.1.1)
(10.10.1.3, 225.1.1.1)
(10.10.1.2, 225.1.1.2)
(10.10.2.1, 225.1.1.2)
(10.10.1.2, 225.1.2.2)
MSDP matched 5 entries
Table 7-2 Description on the fields of the display msdp sa-cache command
(Source, Group)
Origin RP
Pro
AS
Uptime
Expires
Origin RP
10.10.10.10
10.10.10.10
10.10.10.10
10.10.10.10
10.10.10.10
Field
Huawei Technologies Proprietary
7-4
Chapter 7 MSDP Configuration Commands
Pro AS
? ?
? ?
? ?
? ?
? ?
Description
(S, G) entry
Source RP address
Inter-domain unicast routing protocol
AS number
Up time
Expiry of a (S, G) entry
Uptime Expires
00:00:10 00:05:50
00:00:11 00:05:49
00:00:11 00:05:49
00:00:11 00:05:49
00:00:11 00:05:49