Display Poe Interface Power - Huawei Quidway S3900 series Command Manual

Command Manual – PoE & PoE Profile
Quidway S3900 Series Ethernet Switches-Release 1510
ENABLE
MODE
PRIORITY
STATUS

1.1.2 display poe interface power

Syntax
display poe interface power [ interface-type interface-number ]
View
Any view
Parameter
interface-type interface-number: Port on the switch. Refer to Command Manual – Port
for details.
Description
Use the display poe interface power command to view the power information of a
specific port of the switch. If the interface-type interface-number argument is not
specified, the command displays the power information of all ports of the switch.
Example
# Display the power information of Ethernet 1/0/10.
<Quidway> display poe interface power Ethernet1/0/10
Port power
# Display the power information of all ports.
<Quidway> display poe interface power
PORT INDEX
Field
PoE enabled/disabled status on the port
PoE mode on the port:
PoE priority of the port:
PoE status on the port:
:12400 mW
POWER (mW)
Huawei Technologies Proprietary
Chapter 1 PoE Configuration Commands
Description
signal: PoE through the signal cable
spare: PoE through the spare cable
critical: Highest
high: High
low: Low
user command set port to off: PoE to the port is
turned off by the user
Standard PD was detected: A standard PD is
detected
PD detection is in process: PDs are being
detected
PORT INDEX
1-4
POWER (mW)