Loopback-Detection Per-Vlan Enable - Huawei Quidway S3900 series Command Manual

Command Manual – Port Basic Configuration
Quidway S3900 Series Ethernet Switches-Release 1510
undo loopback-detection interval-time
View
System view
Parameter
time: Time interval for loopback detection, in the range of 5 to 300 (in seconds). It is 30
seconds by default.
Description
Use the loopback-detection interval-time command to set time interval for loopback
detection.
Use the undo loopback-detection interval-time command to restore the default time
interval.
Example
# Set time interval for loopback detection to 10 seconds.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] loopback-detection interval-time 10
[Quidway]

1.1.21 loopback-detection per-vlan enable

Syntax
loopback-detection per-vlan enable
undo loopback-detection per-vlan enable
View
Ethernet port view
Parameter
None
Description
Use the loopback-detection per-vlan enable command to configure the system to
run loopback detection on all VLANs of the current trunk or hybrid port.
Use the undo loopback-detection per-vlan enable command to restore the default
setting.
By default, the system runs loopback detection only on the default VLAN of the trunk or
hybrid port.
Huawei Technologies Proprietary
1-21
Chapter 1 Port Basic Configuration
Commands