Huawei Quidway S3900 series Command Manual page 312

Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
Description
Use the display ip routing-table acl command to display the routes that filtered
through a specific basic ACL.
This command is used to track and display the results of route policy. It displays and
only displays the routes that filtered through the basic ACL you specified by an ACL
number.
Example
# Display the summary of the active routes that filtered through basic acl 2000.
[Quidway] acl number 2000
[Quidway-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[Quidway-acl-basic-2000] rule deny source any
[Quidway-acl-basic-2000] display ip routing-table acl 2000
Routes matched by access-list 2000:
Summary count: 2
Destination/Mask
10.1.1.0/24
10.1.1.2/32
InLoopBack0
For detailed description of the output information, see Table 1-1.
# Display the verbose information of the active and inactive routes that filtered through
basic acl 2000.
<Quidway> display ip routing-table acl 2000 verbose
Routes matched by access-list 2000:
+ = Active Route, - = Last Active, # = Both
Destinations: 2
Holddown: 0
**Destination: 10.1.1.0
**Destination: 10.1.1.2
Protocol
DIRECT
Routes: 2
Delete: 0
Protocol: #DIRECT
*NextHop: 10.1.1.2
State: <Int ActiveU Retain Unicast>
Age: 35:37:03
Protocol: #DIRECT
*NextHop: 127.0.0.1
State: <NoAdvise Int ActiveU Retain Gateway Unicast>
Age: 35:37:03
Huawei Technologies Proprietary
Chapter 1 Static Route Configuration
Pre Cost
0 0
DIRECT
Hidden: 0
Mask: 255.255.255.0
Preference: 0
Interface: 10.1.1.2(Vlan-interface1)
Cost: 0/0
Mask: 255.255.255.255
Preference: 0
Interface: 127.0.0.1(InLoopBack0)
Cost: 0/0
1-3
Commands
Nexthop Interface
10.1.1.2 Vlan-interface1
0 0 127.0.0.1
* = Next hop in use