Ntp-Service Unicast-Peer - Huawei Quidway S2000 Series Command Manual

Command Manual - System Management
Quidway S2000 Series Ethernet Switches

7.1.14 ntp-service unicast-peer

Syntax
ntp-service unicast-peer ip-address [ version number ] [ authentication-key keyid ]
[ source-interface { interface-name | interface-type interface-number } ] [ priority ]
undo ntp-service unicast-peer ip-address
View
System view
Parameter
ip-address: Specify the IP address of a remote server.
version: Define NTP version number.
number: NTP version number, ranging from 1 to 3.
authentication-keyid: Define authentication key.
keyid: Key ID used for transmitting messages to a remote server, ranging from 0 to
4294967295.
source-interface: Specify the name of an interface.
interface-name: Specify the interface name. When a local device sends an NTP
message to a peer, the source IP address of the message is taken from the address of
the interface.
interface-type: Specify the interface type and determine an interface together with the
interface-number parameter.
interface-number: Specify the interface number and determine an interface together
with the interface-type parameter.
priority: Designate a server as the first choice.
Description
Using ntp-service unicast-peer command, you can configure NTP peer mode. Using
undo ntp-service unicast-peer command, you can cancel NTP peer mode.
By default, version number number defaults to 3, the authentication is disabled, and the
local server is not the first choice.
This command sets the remote server at ip-address as a peer of the local equipment,
which operates in symmetric active mode. ip-address specifies a host address other
Chapter 7 NTP Configuration Commands
7-12