Enabling 6Pe Peer - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
Exit the system view.
Step 7 Run:
interface interface-type interface-number
The interface view of the IPv4 network is displayed.
Step 8 Run:
mpls
MPLS is enabled on the interface.
Step 9 Run:
mpls ldp
MPLS LDP is enabled on the interface.
----End

11.5.4 Enabling 6PE Peer

By configuring a particular 6PE peer, you can configure a particular 6PE peer to exchange
routing information with the peer configured in the IPv6 view.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp as-number
The BGP view is displayed.
Step 3 Run:
peer ipv4-address as-number as-number
The IP address and the AS number of a specified BGP peer are specified.
Step 4 Run:
peer ipv4-address connect-interface interface-type interface-number
PE peer is specified to connect with a specified interface.
Step 5 Run:
ipv6-family
The BGP-IPv6 unicast address family view is displayed.
Step 6 Run:
peer peer-ipv4-address enable
6PE peer is enabled.
Step 7 Run:
peer peer-ipv4-address label-route-capability
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11 IPv6 over IPv4 Tunnel Configuration
199