Display Qos-Interface Traffic-Priority - H3C s3100 series Command Manual

Parameter
interface-type interface-number: Specifies the type and number of a port, for which the traffic policing
configuration information is to be displayed.
unit-id: Unit ID, which is fixed to 1. With this argument specified, the traffic policing configuration of all
the ports on the device is displayed.
Only H3C S3100-EI series switches support this command.
Description
Use the display qos-interface traffic-limit command to display the traffic policing configuration of a
port or all the ports on the device. This command also displays the traffic policing statistics.
Related command: traffic-limit.
Example
# Display the traffic policing configuration and the corresponding statistics on Ethernet 1/0/1 (assuming
that the current device is an S3100-EI series switch).
<Sysname> display qos-interface Ethernet 1/0/1 traffic-limit
Ethernet1/0/1: traffic-limit
Inbound:
Matches: Acl 2001 rule 0
Target rate: 128 Kbps
Conform action: remark-cos video
Exceed action: drop
meter-statistic running
12 byte outprofile
24 byte inprofile
Refer to Table 1-1

display qos-interface traffic-priority

Syntax
display qos-interface { interface-type interface-number | unit-id } traffic-priority
View
Any view
Parameter
interface-type interface-number: Specifies the type and number of a port, for which the priority marking
configuration information is to be displayed.
running
for the description on the output fields.
1-9