Fuel Filter - Honda CR-V 1997 Service Manual

Fuel Supply System
Fuel Filter
Replacement
not smoke while working on fuel system.
Keep open flame away from your work ar ••.
• While replacing the fuel filt .. , be careful to keep a safe
distance between battery terminals and any tools.
The fuel filter should be replaced whenever the fuel pres-
sure drops below the specified value- with the fuel pres-
sure regulator vacuum hose disconnected and pinched]
after making sure that the fuel pump and the fuel pres-
sure regulator are OK.
*: '97 - 98 models: 260 - 310 kP. (2.7 - 3.2 kgf/em', 38-
46psil
'99 - 00
models:
270 - 320
kPa
(2.8 - 3.2
kgt/em',
40-
47psil
1. Place a shop towel under and around the fuel filter.
2. Relieve fuel pressure (see page 11-1781.
3. Remove the engine wire harness bracket and power
steering feed hose clamp.
4. Remove the banjo bolt and the fuel feed pipe while
supporting the fuel filter with another wrench, as
shown.
5. Remove the fuel fi lter clamp and fuel filter,
6. Install the new fuel filter in the reverse order of
removal , and note these items:
• When assembling, use new washers as shown .
• Clean the flared joint of high pressure hoses
thoroughly before reconnecting them.
11-182
12mm
SEALING
BOLT
33N·m
13.4kgf·m,
251bf-fl1
WASHER
-::::""",~~~.-_-:::::7
Replece.
9.8N·m
11.0 kg/ .... ,
7.211>1'''1