Mac Access-Group - Dell S4810 Reference Manual

Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0

mac access-group

Apply a MAC ACL to traffic entering or exiting an interface. The following interface types can be used for
VLAN , Physical interface, Port channel interface. Enter into the interface mode and apply the mac acl in
the following manner.
S4810
Syntax Applying MAC Access group on a physical / port channel interfacemac access-
group access-list-name {in [vlan vlan-range] | out}
To delete a MAC access-group, use the no mac access-group mac-list-
name command.
Parameters
access-list-
name
vlan vlan-range
in
out
Access Control Lists (ACL)
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Enter the name of a configured MAC access list, up to 140
characters.
(OPTIONAL) Enter the keyword vlan and then enter a range
of VLANs. The range is from 1 to 4094 (you can use IDs 1 to
4094).
NOTE: This option is available only with the keywordin
option.
Enter the keyword in to configure the ACL to filter incoming
traffic.
Enter the keyword out to configure the ACL to filter
outgoing traffic.
NOTE: The option is not available on the S-Series.
247