Dell S4810 Reference Manual page 237

destination
mask
count
byte
log
order
monitor
fragments
Defaults Not configured.
Command CONFIGURATION-EXTENDED-ACCESS-LIST
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Access Control Lists (ACL)
• 20 and 21 = FTP
• 25 = SMTP
• 169 = SNMP
Enter the IP address of the network or host to which the
packets are sent.
Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or non-contiguous.
(OPTIONAL) Enter the keyword count to count packets the
filter processes.
(OPTIONAL) Enter the keyword byte to count bytes the filter
processes.
(OPTIONAL, E-Series only) Enter the keyword log to have
the information kept in an ACL log file.
(OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority). If you do not use the
keyword order, the ACLs have the lowest order by default
(255).
(OPTIONAL) Enter the keyword monitor when the rule is
describing the traffic that you want to monitor and the ACL
in which you are creating the rule is applied to the monitored
interface.
NOTE: For more information, refer to the Flow-based
Monitoring section in the Port Monitoring chapter of the
Dell Networking OS Configuration Guide.
Enter the keyword fragments to use ACLs to control packet
fragments.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
237