Resequence Access-List - Dell S4810 Reference Manual

Example
An ACL rule with a TCP port lt 1023 uses only one entry in the CAM.
Rule# Data
1 0000000000000000 1111110000000000 0
Total Ports: 1024
Related
ip access-list extended
Commands
permit
permit tcp

resequence access-list

Re-assign sequence numbers to entries of an existing access-list.
Syntax
resequence access-list {ipv4 | mac} {access-list-name
StartingSeqNum Step-to-Increment}
Parameters
ipv4 | mac
access-list-
name
StartingSeqNu
m
Step-to-
Increment
Defaults none
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 8.3.11.1
Version 8.1.1.0
Version 7.8.1.0
242
— creates an extended ACL.
— assigns a permit filter for IP packets.
— assigns a permit filter for TCP packets.
Enter the keyword ipv4or mac to identify the access list type
to resequence.
Enter the name of a configured IP access list, up to 140
characters.
Enter the starting sequence number to resequence. The
range is from 0 to 4294967290.
Enter the step to increment the sequence number. The
range is from 1 to 4294967290.
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the E-Series ExaScale (IPv4).
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
Mask From To #Covered
1023 1024
Access Control Lists (ACL)