Permit Tcp - Dell S4810 Reference Manual

Command CONFIGURATION-EXTENDED-ACCESS-LIST
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.3.1.0
Version 8.2.1.0
Version 8.1.1.0
Version 7.6.1.0
Version 7.5.1.0
Version 7.4.1.0
Version 6.5.10
Usage
The order option is relevant in the context of the Policy QoS feature only. For
Information
more information, refer to the "Quality of Service" chapter of the Dell Networking
OS Configuration Guide.
The software cannot count both packets and bytes; when you enter the count byte
options, only bytes are incremented.
Related
ip access-list extended
Commands

permit tcp

permit udp
permit tcp
To pass TCP packets meeting the filter criteria, configure a filter.
S4810
Syntax
permit tcp {source mask | any | host ip-address} [bit]
[operator port [port]] {destination mask | any | host ip-
Access Control Lists (ACL)
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Add the DSCP value for ACL matching.
Allows ACL control of fragmented packets for IP (Layer 3)
ACLs.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Added support for the non-contiguous mask and added the
monitor option.
Expanded to include the optional QoS order priority for the
ACL entry.
— creates an extended ACL.
— assigns a permit filter for TCP packets.
— assigns a permit filter for UDP packets.
235