Timer And Maximum User Number Configuration - Huawei Quidway S3100 Series Operation Manual

Operation Manual – 802.1x
Quidway S3100 Series Ethernet Switches
Operation
Create a RADIUS
scheme and enter
RADIUS
view
Set the IP address
and port number
used
primary
authentication/auth
orization server
Caution:
802.1x-related configurations can all be performed in system view. Port access
control mode and port access method can also be configured in port view.
If you perform a configuration in system view and do not specify the interface-list
argument, the configuration applies to all ports. Configurations performed in
Ethernet port view apply to the current Ethernet port only and the interface-list
argument is not needed in this case.
802.1x configurations take effect only after you enable 802.1x both globally and for
specified ports.

1.4 Timer and Maximum User Number Configuration

Table 1-2 Configure 802.1x timers and the maximum number of users
Operation
Enter system view
Configure
maximum number
of
on-line users for
specified ports
Command
radius
scheme radius-scheme-name
by the primary
RADIUS ip-address [ port-number ]
Command
system-view
In system view:
dot1 x
the
user-number
inter face-list ]
concurrent
In port view:
dot1x
user-number
Huawei Technologies Proprietary
Optional
The default RADIUS scheme
is "system". This command is
scheme
required if the name of the
RADIUS scheme adopted in
the
"system".
Optional
This command is required if
authentication
the name of the RADIUS
scheme adopted in the ISP
domain is not "system".
—
max-user
Optional
[ interface
By
concurrent on-line users are
allowed on each port.
max-user
1-15
Chapter 1 802.1x Configuration
Description
ISP domain is
Description
default, up to
not
256