Enabling Stateful Auto Configuration; Configuring The Address Prefixes To Be Advertised - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - IP Service
The interval for advertising RA messages is configured.
By default, the maximum interval is 600 seconds and the minimum interval is 200 seconds.
The maximum interval can not be shorter than the minimum interval.
When the maximum interval is less than 9 seconds, the minimum interval is set to the same value
as the maximum interval.
----End

9.4.5 Enabling Stateful Auto Configuration

After being enabled with stateful auto-configuration, the host can obtain an IPv6 address through
stateful auto-configuration, for example, the DHCP server.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
Step 3 Run:
ipv6 enable
You can enable the IPv6 capability.
Step 4 Run:
ipv6 nd autoconfig managed-address-flag
The flag bit for stateful auto configuration addresses is set.
If this flag is set, hosts use the stateful protocol for address auto-configuration in addition to any
addresses auto-configured using stateless address auto-configuration.
Step 5 Run:
ipv6 nd autoconfig other-flag
The flag bit for other stateful configurations is set.
When this flag is set, hosts use the stateful protocol for auto-configuration of other (non-address)
information.
----End

9.4.6 Configuring the Address Prefixes to Be Advertised

Nodes of the local links can perform address auto-configuration by using prefixes of these
addresses.
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Basic Configurations of IPv6
159