Show Stpd - Extreme Networks ExtremeWare Command Reference Manual

STP Commands

show stpd

show stpd {<spanning tree name> | detail}
Description
Displays STPD settings on the switch.
Syntax Description
spanning tree name
detail
Default
N/A.
Usage Guidelines
The command displays the following STPD information:
• STPD name
• STPD state
• STPD mode of operation
• Rapid Root Failover
• Tag
• Ports
• Active VLANs
• Bridge Priority
• Bridge ID
• Designated root
• STPD configuration information
You can create, configure, and enable one or more STP domains and use the
display STP configurations. Use the
enable stpd {<spanning tree name>}
knowledge and experience with STP, you can configure the STPD using the
commands. However, the default STP parameters are adequate for most networks.
Example
The following command displays STPD settings on an STPD named Backbone_st:
show stpd backbone_st
The results for this command are as follows:
* Alpine3804:47 # show stpd Backbone_st
Stpd: Backbone_st Stp: ENABLED
1036
Specifies an STPD on the switch.
Specifies that STPD settings should be shown for each STPD.
create stpd <name>
command to enable an STPD. If you have considerable
Number of Ports: 0
show stpd
command to create an STP domain. Use the
configure stpd
ExtremeWare Software 7.3.0 Command Reference Guide
command to