Show Stpd - Extreme Networks ExtremeWare Command Reference Manual

STP Commands

show stpd

show stpd {<spanning tree name> | detail}
Description
Displays STPD settings on the switch. If an MSTP domain exists, the output includes the MSTP
configuration.
Syntax Description
spanning tree name Specifies an STPD on the switch.
NOTE: This option is available only on the "i" series switches.
detail Specifies that STPD settings should be shown for each STPD.
NOTE: This option is available only on the "i" series switches.
domain Specifies an STPD on the switch. Supported on e platform switches.
Default
N/A
Usage Guidelines
The command displays the following STPD information:
• STPD name
• STPD state
• STPD mode of operation
• Rapid Root Failover
• Tag
• Ports
• Active VLANs
• Bridge Priority
• Bridge ID
• Designated root
• STPD configuration information
You can create, configure, and enable one or more STP domains and use the
display STP configurations. Use the
command to enable an STPD. If you have considerable knowledge and experience with STP, you
stpd
can configure the STPD using the
are adequate for most networks.
Examples
The following command displays global STPD settings for a system with MSTP configured:
show stpd
1624
command to create an STP domain. Use the
create stpd
commands. However, the default STP parameters
configure stpd
command to
show stpd
enable
ExtremeWare 7.7 Command Reference Guide