Monitoring Tunnel Subscriber Authentication - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

Table 13: show aaa domain-map Output Fields (continued)
Related Topics

Monitoring Tunnel Subscriber Authentication

Verify configuration of tunnel subscriber authentication. When authentication is
Purpose
enabled, the output indicates this configuration. When authentication is disabled,
the output presents no information about the configuration.
To display tunnel subscriber authentication configuration:
Action
Field Name
Tunnel Source
Tunnel Type
Tunnel Medium
Tunnel Password
Tunnel Id
Tunnel Client Name
Tunnel Server Name
Tunnel Preference
Tunnel Max Sessions
Tunnel RWS
Tunnel Virtual Router
Tunnel Failover Resync
Tunnel Switch Profile
Tunnel Tx Speed Method
show aaa domain-map
Chapter 2: Monitoring and Troubleshooting Remote Access
Field Description
Source address of the tunnel
L2TP
Type of medium for the tunnel; only IPv4 is supported
Password for the tunnel
ID of the tunnel
Host name that the LAC sends to the LNS when
communicating to the LNS about the tunnel
Host name expected from the peer (the LNS) when
during tunnel startup
Preference level for the tunnel
Maximum number of sessions allowed on a tunnel
L2TP receive window size (RWS) for a tunnel on the
LAC; displays either the configured value or the
default behavior, which is indicated by system
chooses
Name of the virtual router to map to the user domain
name
L2TP peer resynchronization method
Name of the L2TP tunnel switch profile
Method that the router uses to calculate the transmit
connect speed of the subscriber's access interface:
static layer2, dynamic layer2, qos, actual, not set
Monitoring Tunnel Subscriber Authentication
117