Downgrade Procedures; Removing The Management System - Juniper NETWORK AND SECURITY MANAGER 2010.4 - INSTALLATION GUIDE REV1 Installation Manual

Network and Security Manager Installation Guide

Downgrade Procedures

Removing the Management System

188
/usr/netscreen/DevSvr/bin/devSvr.sh start
Verify that the server processes are running:
10.
/usr/netscreen/HaSvr/bin/haSvr.sh status
/usr/netscreen/GuiSvr/bin/guiSvr.sh status
/usr/netscreen/DevSvr/bin/devSvr.sh status
To downgrade to your previous version of NSM, you need to reinstall that version of NSM,
and restore your old data.
NOTE: Before downgrading, check the audit log for any changes made since
the upgrade that you might need to restore once the downgrade is complete.
To downgrade from NSM:
Make a backup copy of all your existing data.
1.
Remove the management system. See "Removing the Management System" on
2.
page 188 for more information.
Install your previous version of NSM.
3.
Restore your backup database. See "Restoring the Database" on page 182 for more
4.
information.
To remove previous management system installations:
Stop the HA Server by entering the following command:
1.
/usr/netscreen/HaSvr/bin/haSvr.sh stop
Stop the Device Server by entering the following command:
2.
/usr/netscreen/DevSvr/bin/devSvr.sh stop
Stop the GUI Server by entering the following commands:
3.
/usr/netscreen/GuiSvr/bin/guiSvr.sh stop
For systems running Linux:
4.
a. Navigate to the /usr
subdirectory.
rpm -e netscreen-DevSvr
rpm -e netscreen-GuiSvr
rpm -e netscreen-HaSvr
rm -rf netscreen
b. Navigate to the
/var
subdirectory.
subdirectory, and remove all the files in the netscreen
subdirectory, and remove all the files in the netscreen
Copyright © 2010, Juniper Networks, Inc.