Figure 37: Attaching Qos Profiles To Atm Subinterfaces - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - QUALITY OF SERVICE CONFIGURATION GUIDE 2010-09-22 Configuration Manual

Copyright © 2010, Juniper Networks, Inc.

Figure 37: Attaching QoS Profiles to ATM Subinterfaces

To configure this example:
Create and configure QoS profile qp1.
1.
host1(config)#qos-profile qp-1
host1(config-qos-profile)#atm-vp node scheduler-profile sp1
host1(config-qos-profile)#atm-vc queue traffic-class tc1 scheduler-profile sp1
queue-profile qp1
host1(config-qos-profile)#atm-vc queue traffic-class tc2 scheduler-profile sp2
queue-profile qp2
host1(config-qos-profile)#atm-vc queue traffic-class tc3 scheduler-profile sp3
queue-profile qp3
host1(config-qos-profile)#atm-vc queue traffic-class tc4 scheduler-profile sp4
queue-profile qp4
host1(config-qos-profile)#atm-vc queue traffic-class tc5 scheduler-profile sp5
queue-profile qp5
host1(config-qos-profile)#exit
Create and configure QoS profile qp2.
2.
host1(config)#qos-profile qp2
host1(config-qos-profile)#atm-vp node scheduler-profile sp1
host1(config-qos-profile)#atm-vc queue traffic-class tc1 scheduler-profile sp1
queue-profile qp1
host1(config-qos-profile)#atm-vc queue traffic-class tc2 scheduler-profile sp2
queue-profile qp2
host1(config-qos-profile)#atm-vc queue traffic-class tc3 scheduler-profile sp3
queue-profile qp3
host1(config-qos-profile)#exit
Attach the QoS profiles to the ATM subinterfaces, as shown in Figure 37 on page 133.
3.
host1(config)#interface atm 11/0.1
host1(config-subif)#qos-profile qp1
host1(config-subif)#exit
host1(config)#interface atm 11/0.2
host1(config-subif)#qos-profile qp2
host1(config-subif)#exit
Display the QoS interface hierarchy for ATM interface 11/0. This display shows all QoS
4.
attachments above interface 11/0.
If no QoS profiles are attached above the specified interface, the router shows the
first attachment below the specified interface.
Chapter 16: Configuring and Attaching QoS Profiles to an Interface
133