Table 515: Show Mpls Path Output Fields - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos
show mpls path
Syntax
Syntax (EX Series
Switch)
Release Information
Description
Options
Required Privilege
Level
List of Sample Output
Output Fields
show mpls path show mpls path
3786
®
OS for EX Series Ethernet Switches, Release 10.4
show mpls path
<logical-system (all | logical-system-name)>
<path-name>
show mpls path
<path-name>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.5 for EX Series switches.
Display dynamic Multiprotocol Label Switching (MPLS) label-switched paths (LSPs).
—Display standard information about all MPLS LSPs.
none
logical-system (all | logical-system-name)
systems or on a particular logical system.
—(Optional) Display information about the specified LSP only.
path-name
view
show mpls path on page 3786
Table 515 on page 3786 describes the output fields for the
Output fields are listed in the approximate order in which they appear.

Table 515: show mpls path Output Fields

Field Name
Path name
Address
Strict/loose address
user@host> show mpls path
Path name Address
p1 123.456.55.6
123.456.1.6
p2 191.456.1.4
—(Optional) Perform this operation on all logical
Field Description
Information about ingress LSPs. Each path has one line of output.
Addresses of the routing devices that form the LSP.
Whether the address is a configured as a strict or loose address.
Strict/loose address
Strict
Loose
Strict
show mpls path command.
Copyright © 2010, Juniper Networks, Inc.