Clear Mpls Lsp - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos

clear mpls lsp

Syntax
Syntax (EX Series
Switch)
Release Information
Description
Options
3724
®
OS for EX Series Ethernet Switches, Release 10.4
clear mpls lsp
<autobandwidth>
<logical-system (all | logical-system-name)>
<name name>
<optimize | optimize-aggressive>
<path regular-expression>
<statistics>
clear mpls lsp
<autobandwidth>
<name name>
<optimize | optimize-aggressive>
<path regular-expression>
<statistics>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.5 for EX Series switches.
Release the routes and states associated with MPLS label-switched paths (LSPs), and
start new LSPs.
CAUTION: This command disconnects existing Resource Reservation Protocol
(RSVP) sessions on the ingress routing device. If there is a time lag between
the old path being torn down and the new path being set up, this command
might impact traffic traveling along the LSPs.
—Reset and restart all LSPs that originated from this routing device; that is, all LSPs
none
for which this routing device is the ingress routing device. Depending on the number
of LSPs involved, it might take a while to restart all the LSPs.
—(Optional) Clear LSP autobandwidth counters.
autobandwidth
logical-system (all | logical-system-name)
systems or on a particular logical system.
—(Optional) Reset and restart the specified LSP or group of LSPs. You can
name name
include wildcard characters in the interface name, as described in the Junos Network
Interfaces Configuration Guide.
optimize | optimize-aggressive
optimization computation now.
—(Optional) Clear the specific LSP path matching the specified
path regular-expression
regular expression.
—(Optional) Clear LSP statistics.
statistics
—(Optional) Perform this operation on all logical
—(Optional) Run nonpreemptive optimization or aggressive
Copyright © 2010, Juniper Networks, Inc.