Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 3881

Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields
Table 514: show mpls lsp Output Fields
Field Name Field Description
Information about LSPs on the ingress routing device. Each session has one line
Ingress LSP
of output.
Copyright © 2010, Juniper Networks, Inc.
command is only valid for the ingress routing device, because the description is not
propagated in RSVP messages.
—(Optional) Display only LSPs that are inactive or active, respectively.
down | up
logical-system (all | logical-system-name)
systems or on a particular logical system.
—(Optional) Display information about a particular LSP type:
lsp-type
—Sessions for bypass LSPs.
bypass
—Sessions that terminate on this routing device.
egress
—Sessions that originate from this routing device.
ingress
—Sessions that pass through this routing device.
transit
name name —(Optional) Display information about the specified LSP or group of LSPs.
—(Optional) Display information about point-to-multipoint LSPs.
p2mp
—(Optional) (Egress and transit routers only) Display accounting information
statistics
about LSPs. Statistics are not available for LSPs on the egress routing device, because
the penultimate routing device in the LSP sets the label to 0. Also, as the packet
arrives at the egress routing device, the hardware removes its MPLS header and the
packet reverts to being an IPv4 packet. Therefore, it is counted as an IPv4 packet,
not an MPLS packet.
—(Optional) Display LSPs transiting this routing device.
transit
view
clear mpls lsp on page 3724
show mpls lsp defaults on page 3782
show mpls lsp descriptions on page 3783
show mpls lsp detail on page 3783
show mpls lsp extensive on page 3783
show mpls lsp ingress extensive on page 3784
show mpls lsp p2mp on page 3784
show mpls lsp p2mp detail on page 3785
Table 514 on page 3777 describes the output fields for the
fields are listed in the approximate order in which they appear.
Chapter 137: Operational Commands for MPLS
—(Optional) Perform this operation on all logical
show mpls lsp
command. Output
Level of Output
All levels
3777