Understanding Cos Two-Color Marking; Understanding Cos Rewrite Rules; How Rewrite Rules Work - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos

Understanding CoS Two-Color Marking

Related
Documentation

Understanding CoS Rewrite Rules

How Rewrite Rules Work

3390
®
OS for EX Series Ethernet Switches, Release 10.4
Networks police traffic by limiting the input or output transmission rate of a class of traffic
on the basis of user-defined criteria. Policing traffic allows you to control the maximum
rate of traffic sent or received on an interface and to partition a network into multiple
priority levels or classes of service.
Policers require you to apply limits to the traffic flow and set a consequence for packets
that exceed these limits—usually a higher loss priority, so that packets exceeding the
policer limits are discarded first.
Juniper Networks EX Series Ethernet Switches support a single-rate two-color marking
type of policer, which is a simplified version of Single-Rate-Three-Color marking, defined
in RFC 2697, A Single Rate Three Color Marker. This type of policer meters traffic based
on the configured committed information rate (CIR) and committed burst size (CBS).
The single-rate two-color marker meters traffic and marks incoming packets depending
on whether they are smaller than the committed burst size (CBS)—marked green—or
exceed it— marked red.
The single-rate two-color marking policer operates in color-blind mode. In this mode,
the policer's actions are not affected by any previous marking or metering of the examined
packets. In other words, the policer is "blind? to any previous coloring a packet might
have had.
Understanding Junos OS CoS Components for EX Series Switches on page 3376
Understanding the Use of Policers in Firewall Filters on page 3259
Configuring Policers to Control Traffic Rates (CLI Procedure) on page 3300
As packets enter or exit a network, edge switches might be required to alter the
class-of-service (CoS) settings of the packets. This topic describes how to use rewrite
rules to alter the CoS settings. It covers:
How Rewrite Rules Work on page 3390
Default Rewrite Rule on page 3391
Rewrite rules set the value of the CoS bits within the packet's header. Each rewrite rule
reads the current forwarding class and loss priority associated with the packet, locates
the chosen CoS value from a table, and writes this CoS value into the packet header. For
rewrites to occur, rewrite rules must be explicitly assigned to an interface. Only tagged
Layer 3 interfaces and tagged routed VLAN interfaces (RVIs) automatically rewrite
packets by using the default IEEE 802.1p rewrite rule. Multiple rewrite rules of different
types can be assigned to a single interface.
Copyright © 2010, Juniper Networks, Inc.