Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 3981

Results
Purpose
Action
Meaning
Purpose
Copyright © 2010, Juniper Networks, Inc.
NOTE: If you set only the
will be disabled.
Check the results of the configuration:
[edit protocols sflow]
user@switch# show
polling-interval 20;
sample-rate egress 1000;
collector 10.204.32.46 {
udp-port 5600;
}
interfaces ge-0/0/0.0;
Verification
To confirm that the configuration is correct, perform these tasks:
Verifying That sFlow Technology Has Been Configured Properly on page 3877
Verifying That sFlow Technology Is Enabled on the Intended Interface on page 3877
Verifying the sFlow Collector Configuration on page 3878
Verifying That sFlow Technology Has Been Configured Properly
Verify that sFlow technology has been configured properly.
Use the command:
show sflow
user@switch> show sflow
sFlow: Enabled
Sample limit: 300 packets/second
Polling interval: 20 seconds
Sample rate egress: 1:1000: Enabled
Sample rate ingress: 1:2048: Disabled
Agent ID: 10.204.96.222
NOTE: The sample limit cannot be configured and is set to 300
packets/second.
The output shows that sFlow technology is enabled and specifies the values for the
sample limit, polling interval, and sample rate.
Verifying That sFlow Technology Is Enabled on the Intended Interface
Verify that sFlow technology is enabled on interfaces and display the sampling
parameters.
Chapter 139: sFlow Monitoring Technology
egress sample rate, the ingress sample rate
3877