Configuring Firewall Filters (J-Web Procedure) - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos
Related
Documentation

Configuring Firewall Filters (J-Web Procedure)

3296
®
OS for EX Series Ethernet Switches, Release 10.4
[edit interfaces]
user@switch# set ge-0/1/0 unit 0 family inet address 10.10.10.1/24 filter output
egress-router-filter
NOTE: You can apply no more than one firewall filter per Layer 3 interface,
per direction.
Configuring Firewall Filters (J-Web Procedure) on page 3296
Example: Configuring Firewall Filters for Port, VLAN, and Router Traffic on EX Series
Switches on page 3261
Example: Using Filter-Based Forwarding to Route Application Traffic to a Security
Device on EX Series Switches on page 3280
Example: Configuring a Firewall Filter on a Management Interface on an EX Series
Switch on page 3284
Verifying That Firewall Filters Are Operational on page 3311
Monitoring Firewall Filter Traffic on page 3312
Configuring Policers to Control Traffic Rates (CLI Procedure) on page 3300
You configure firewall filters on EX Series switches to control traffic that enters ports on
the switch or enters and exits VLANs on the network and Layer 3 (routed) interfaces. To
configure a firewall filter you must configure the filter and then apply it to a port, VLAN,
or Layer 3 interface.
To configure firewall filter settings using the J-Web interface:
Select >
1. Configure Security
The Firewall Filter Configuration page displays a list of all configured port/VLAN or
router filters and the ports or VLANs associated with a particular filter.
NOTE: After you make changes to the configuration in this page, you must
commit the changes for them to take effect. To commit all changes to
the active configuration, select
Commit Options to Commit Configuration Changes for details about all
commit options.
Click one:
2.
> .
Filters
Commit Options
Copyright © 2010, Juniper Networks, Inc.
> . See Using the
Commit