Table 553: Logical Operators For The Monitor Traffic Command - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Table 552: Match Conditions for the monitor traffic Command (continued)
Match Type
Protocol

Table 553: Logical Operators for the monitor traffic Command

Logical Operator (Highest to Lowest Precedence)
!
Copyright © 2010, Juniper Networks, Inc.
Chapter 146: Operational Commands for General Network Management and Monitoring
Condition
amt
arp
ether
ether [broadcast | multicast]
ether protocol [address | (arp | ip | rarp)]
icmp
ip
ip [broadcast | multicast]
ip protocol [address | (icmp | igrp | tcp | udp)]
isis
rarp
tcp
udp
To combine expressions, use the logical operators listed in Table 553 on page 4151.
Description
Logical NOT. If the first condition does not match, the next condition
is evaluated.
Description
Matches all AMT packets. Use the extensive
level of output to decode the inner IGMP
packets in addition to the AMT outer packet.
Matches all ARP packets.
Matches all Ethernet packets.
Matches broadcast or multicast Ethernet
frames. This match condition can be
prepended with and .
src dst
Matches packets with the specified Ethernet
address or Ethernet packets of the specified
protocol type. The
ether protocol
, , and are also independent match
arp ip rarp
conditions, so they must be preceded by a
backslash ( ) when used in the
\
match condition.
Matches all ICMP packets.
Matches all IP packets.
Matches broadcast or multicast IP packets.
Matches packets with the specified address
or protocol type. The ip protocol
icmp , tcp , and udp are also independent
match conditions, so they must be preceded
by a backslash ( \ ) when used in the
match condition.
protocol
Matches all IS-IS routing messages.
Matches all RARP packets.
Matches all TCP datagrams.
Matches all UDP datagrams.
arguments
ether protocol
arguments
ip
4151