Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 3762

Complete Software Guide for Junos
Table 496: Components of the Egress PE Switch in Topology for MPLS with Interface-Based
CCC
Property
Remote PE switch hardware
Loopback address
Routing protocol
MPLS protocol and definition of
label-switched path
RSVP protocol
Interface family
Customer-edge interface
Core interface
CCC definition
3658
®
OS for EX Series Ethernet Switches, Release 10.4
Table 496 on page 3658 shows the MPLS configuration components used for the egress
PE switch in this example.
Settings
EX Series switch
lo0 127.1.1.3/32
ospf traffic-engineering
mpls
label-switched-path lsp_to_pe1_ge1
to 127.1.1.1
rsvp
family inet
family mpls
family ccc
ge-0/0/1
with IP address
ae0
connections remote-interface-switch
ge-1-to-pe1
interface ge-0/0/1.0
transmit-lsp lsp_to_pe1_ge1;
receive-lsp lsp_to_pe2_ge1;
Description
PE-2
Identifies PE-2 for interswitch
communications.
Indicates that this switch is using OSPF
as the routing protocol and that traffic
engineering is enabled.
Indicates that this PE switch is using the
MPLS protocol with the specified
label-switched path (LSP) to reach the
other PE switch.
The statement must also specify the
core interfaces to be used for MPLS
traffic.
Indicates that this switch is using the
RSVP protocol. The statement must
specify the loopback address and the
core interfaces that will be used for the
RSVP session.
The logical unit of the core interface is
configured to belong to both
and family mpls
The logical unit of the customer-edge
interface is configured to belong to
family ccc
Interface that connects this network to
devices outside the network.
Aggregated Ethernet interface on PE-2
10.1.9.2/24
that connects to aggregated Ethernet
interface
belongs to
Associates the CCC,
LSPs that have been defined on the local
and remote PE switches.
Copyright © 2010, Juniper Networks, Inc.
family inet
.
.
of the provider switch and
ae0
.
family mpls
, with the
ge-0/0/1