Specifying Policers In A Firewall Filter Configuration; Applying A Firewall Filter That Is Configured With A Policer - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos

Specifying Policers in a Firewall Filter Configuration

Applying a Firewall Filter That Is Configured with a Policer

Related
Documentation
3302
®
OS for EX Series Ethernet Switches, Release 10.4
To reference a policer for a single firewall, configure a filter term that includes the policer
action:
[edit firewall family ethernet-switching]
user@switch# set filter limit-hosts term term-one from source-address 192.0.2.16/28
userswitch# set filter limit-hosts term term-one then policer policer-one
A firewall filter that is configured with one or more policer actions, like any other filter,
must be applied to a port, VLAN, or Layer 3 interface. For information about applying
firewall filters, see the sections on applying firewall filters in "Configuring Firewall Filters
(CLI Procedure)" on page 3289.
NOTE: You can include policer actions on ingress firewall filters only.
Example: Configuring Firewall Filters for Port, VLAN, and Router Traffic on EX Series
Switches on page 3261
Configuring Firewall Filters (CLI Procedure) on page 3289
Configuring Firewall Filters (J-Web Procedure) on page 3296
Verifying That Policers Are Operational on page 3312
Understanding the Use of Policers in Firewall Filters on page 3259
Copyright © 2010, Juniper Networks, Inc.