Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 4107

Table 539: RPM Probe Owner, Concurrent Probes, and Probe Servers Configuration Fields
Field
Probe Owners
Maximum Number of Concurrent Probes
Copyright © 2010, Juniper Networks, Inc.
NOTE:
EX Series switches support hardware timestamps for UDP and ICMP probes.
EX Series switches do not support hardware timestamps for HTTP or TCP
probes.
If the responder does not support hardware timestamps, RPM can only
report the round-trip measurements, it cannot calculate round-trip jitter.
In EX Series switches timestamps apply only to IPv4 traffic.
To configure RPM using the J-Web interface:
Select >
1. Troubleshoot RPM
In the page, enter information as specified in Table 539 on page 4003.
Configure RPM
2.
Click to set up the
a. Add
Select a probe owner from
b.
probe owner
Double-click one of the probe owners in
c.
performance probe tests.
Double-click one of the performance probe tests to edit the test parameters.
d.
Enter the
3. Maximum Number of Concurrent Probes
Click to apply the RPM probe settings.
Apply
4.
Function
Identifies a owner for whom one or more
RPM tests are configured. In most
implementations, the owner name
identifies a network on which a set of
tests is being run.
Specifies the maximum number of
concurrent probes allowed.
Chapter 141: Real-Time Performance Monitoring (RPM)
> .
Configure RPM
and
Owner Name Performance Probe Tests
list and click
Probe Owners
Probe Owners
and specify the
Your Action
1. Click
2. In
to define the RPM test parameters.
See Table 540 on page 4004 for
information on configuring RPM test
parameters.
3. Click
Cancel
without saving the changes.
Type a number from 1 through 500.
.
to remove the selected
Delete
list to display the list of
Probe Servers
and type an owner name.
Add
, click
Performance Probe Tests
to save the settings or
OK
to exit from the window
.
Add
4003