Table 40: Show Mpls L2Transport Interface Output Fields - Juniper POLICY MANAGEMENT - CONFIGURATION GUIDE V11.1.X Configuration Manual

JUNOSe 11.1.x Policy Management Configuration Guide
Table 40 on page 202 lists the show mpls l2transport interface command output
Meaning
fields.

Table 40: show mpls l2transport interface Output Fields

202
Monitoring the Policy Configuration of Layer 2 Services over MPLS
MPLS policy input mplsInputPolicy
classifier-group claclWst50 entry 1
0 packets, 0 bytes
rate-limit-profile rlp
committed: 0 packets, 0 bytes, action: transmit
conformed: 0 packets, 0 bytes, action: transmit
exceeded: 0 packets, 0 bytes, action drop
MPLS policy output mplsOutputPolicy
classifier-group claclWst75 entry 1
0 packets, 0 bytes
rate-limit-profile rlp
committed: 0 packets, 0 bytes, action: transmit
conformed: 0 packets, 0 bytes, action: transmit
exceeded: 0 packets, 0 bytes, action: drop
Field Name
Interface
base-LSP/remote-addr
group-id
vc-id
mtu
state/in/out-label
Mpls Statistics
pkts
hcPkts
octets
hcOctets
errors
discardPkts
queue, traffic class, bound to
Field Description
Specifier and status of each interface
Identifies either the tunnel that is selected to
forward the traffic or the address of the router
at the other end
Group ID number for the interface
VC ID number for the interface
Maximum transmission unit for the interface
Status of the Layer 2-over-MPLS connection or
the incoming/outgoing VC label
Number of packets received or sent
Number of high-capacity (64-bit) packets
received or sent
Number of octets received or sent
Number of high-capacity (64-bit) octets received
or sent
Number of packets that are dropped for some
reason at receipt or before being sent
Number of packets that are discarded due to
lack of buffer space at receipt or before being
sent
Queue and traffic class bound to the specified
interface