Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 4185

Results
Purpose
Action
Sample Output
Copyright © 2010, Juniper Networks, Inc.
Enable the continuity check protocol and specify the continuity check hold interval:
4.
[edit protocols oam ethernet connectivity-fault-management
maintenance-domain private maintenance-association private-ma]user@switch2#
set continuity-check hold-interval 1s
Configure the maintenance association end point (MEP)
5.
[edit protocols oam ethernet connectivity-fault-management
maintenance-domain private maintenance-association private-ma]
user@switch2# set mep 100 interface ge-0/2/5 auto-discovery direction down
Check the results of the configuration.
[edit]
user@switch2# show
protocols {
oam {
ethernet {
connectivity-fault-management {
maintenance-domain private {
level 0;
maintenance-association private-ma {
continuity-check {
interval 1s;
}
mep 100 {
interface ge-0/2/5;
auto-discovery;
direction down;
}
}
}
}
}
Verification
To confirm that the configuration is working properly, perform these tasks:
Verifying That OAM CFM Has Been Configured Properly on page 4081
Verifying That OAM CFM Has Been Configured Properly
Verify that OAM CFM has been configured properly.
Use the show oam ethernet connectivity-fault-management interfaces detail command:
user@switch1# show oam ethernet connectivity-fault-management interfaces detail
Interface name: ge-1/0/1.0, Interface status: Active, Link status: Up
Maintenance domain name: private, Format: string, Level: 0
Maintenance association name: private-ma, Format: string
Continuity-check status: enabled, Interval: 1ms, Loss-threshold: 3 frames
MEP identifier: 100, Direction: down, MAC address: 00:90:69:0b:4b:94
MEP status: running
Defects:
Remote MEP not receiving CCM
Erroneous CCM received
Chapter 143: Ethernet OAM Connectivity Fault Management
: no
: yes
4081