Configuring Routing Policies (J-Web Procedure) - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos
Related
Documentation

Configuring Routing Policies (J-Web Procedure)

3304
®
OS for EX Series Ethernet Switches, Release 10.4
Because loss of network-generated packets can jeopardize proper network
operation, delay is preferable to discard of packets. The following term,
, assigns the forwarding class
network-traffic
:
low
[edit firewall family ethernet-switching filter ingress-filter]
user@switch# set term network-traffic from precedence net-control
user@switch# set term network-traffic then forwarding-class network
user@switch# set term network-traffic then loss-priority low
The last term
accept-traffic
preceding terms and assigns the forwarding class
:
low
[edit firewall family ethernet-switching filter ingress-filter]
user@switch# set term accept-traffic from precedence net-control
user@switch# set term accept-traffic then forwarding-class best-effort
user@switch# set term accept-traffic then loss-priority low
Apply the filter ingress-filter
3.
applying the filter, see "Configuring Firewall Filters (CLI Procedure)" on page 3289.
Example: Configuring Firewall Filters for Port, VLAN, and Router Traffic on EX Series
Switches on page 3261
Verifying That Firewall Filters Are Operational on page 3311
Monitoring Firewall Filter Traffic on page 3312
Defining CoS Classifiers (CLI Procedure) on page 3432
Defining CoS Classifiers (J-Web Procedure) on page 3434
Configuring Firewall Filters (CLI Procedure) on page 3289
Configuring Firewall Filters (J-Web Procedure) on page 3296
All routing protocols use the Junos OS routing table to store the routes that they learn
and to determine which routes are advertised in the protocol packets. Routing policy
allows you to control which routes the routing protocols store in and retrieve from the
routing table on the routing device.
To configure routing policies for an EX Series switch using the J-Web interface:
Select >
1. Configure Routing
NOTE: After you make changes to the configuration in this page, you must
commit the changes for them to take effect. To commit all changes to
the active configuration, select
Commit Options to Commit Configuration Changes for details about all
commit options.
network-control
matches any packets that did not match on any of the
best-effort
to a port, VLAN or Layer 3 interface. For information about
> .
Policies
Commit Options
Copyright © 2010, Juniper Networks, Inc.
and packet loss priority
and packet loss priority
> . See Using the
Commit