Show Link-Management Routing; Table 504: Show Link-Management Peer Output Fields - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos
show link-management peer
Syntax
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields

Table 504: show link-management peer Output Fields

Field Name Field Description
Peer Name Name of the peer.
System identifier Internal identifier for the peer. The range of values is
State State of the peer:
Control address Address to which a control channel is established.
Hello interval How often the routing device sends Link Management Protocol (LMP) hello packets.
Hello dead interval How long LMP waits before declaring the control channel to be dead. This is an interval during which
the routing device receives no LMP hello packets from the neighbor on a control that is active or up.
Identifier assigned to the control channel by the local peer. The range of values is
CC local ID
4,294,967,296
Identifier assigned to the control channel by the remote peer. The range of values is
CC remote ID
4,294,967,296
3758
®
OS for EX Series Ethernet Switches, Release 10.4
show link-management peer
<name peer-name>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.5 for EX Series switches.
Display Multiprotocol Label Switching (MPLS) peer link information.
none —Display all peer link information.
—(Optional) Display information for the specified peer only.
name peer-name
view
show link-management on page 3754
show link-management routing on page 3760
show link-management statistics on page 3763
show link-management te-link on page 3765
show link-management peer on page 3759
Table 504 on page 3758 describes the output fields for the
command. Output fields are listed in the approximate order in which they appear.
Up or Down .
.
.
show link-management peer
0 through 64,000 .
1
Copyright © 2010, Juniper Networks, Inc.
through
through
1