Continuity-Check (Ex Series Switch Only); Direction (Ex Series Switch Only) - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos

continuity-check (EX Series Switch Only)

Syntax
Hierarchy Level
Release Information
Description
Required Privilege
Level
Related
Documentation

direction (EX Series Switch Only)

Syntax
Hierarchy Level
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
4096
®
OS for EX Series Ethernet Switches, Release 10.4
continuity-check {
hold-interval minutes;
interval (10m | 10s | 1m | 1s| 100ms);
loss-threshold number;
}
[edit protocols oam ethernet connectivity-fault-management maintenance-domain
domain-name maintenance-association ma-name]
Statement introduced in Junos OS Release 10.2 for EX Series switches.
Specify continuity check protocol options.
The remaining statements are explained separately.
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
Configuring Ethernet OAM Connectivity Fault Management (CLI Procedure) on page 4082
Junos OS Network Interfaces Configuration Guide
direction down;
[edit protocols oam ethernet connectivity-fault-management maintenance-domain
domain-name maintenance-association ma-name mep mep-id]
Statement introduced in Junos OS Release 10.2 for EX Series switches.
Specify that connectivity fault management (CFM) packets (CCMs) be transmitted only
in one direction for the MEP, that is, the direction be set as
transmitted only out of (not into) the interface configured on this MEP.
down —Down MEP CCMs are transmitted only out (not into) of the interface configured
on this MEP.
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
Configuring Ethernet OAM Connectivity Fault Management (CLI Procedure) on page 4082
Junos OS Network Interfaces Configuration Guide
so that CCMs are
down
Copyright © 2010, Juniper Networks, Inc.