Defining Cos Scheduler Maps (J-Web Procedure) - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Table 455: Schedulers Configuration Page (continued)
Field
Transmit Rate
Related
Documentation

Defining CoS Scheduler Maps (J-Web Procedure)

Copyright © 2010, Juniper Networks, Inc.
Function
Defines the transmission rate of a scheduler.
The transmit rate determines the traffic
bandwidth from each forwarding class you
configure.
By default, queues 0 through 7 are allotted the
following percentage of the transmission
capacity:
Queue 0—95 percent
Queue 1—0 percent
Queue 2—0 percent
Queue 3—5 percent
Queue 4—0 percent
Queue 6—0 percent
Queue 7—5 percent
Defining CoS Schedulers (CLI Procedure) on page 3437
Example: Configuring CoS on EX Series Switches on page 3401
Monitoring CoS Scheduler Maps on page 3459
You can use the J-Web interface to configure CoS scheduler maps on an EX Series switch.
To configure scheduler maps:
Select Configure > Class of Service
1.
NOTE: After you make changes to the configuration in this page, you must
commit the changes immediately for them to take effect. To commit all
changes to the active configuration, select
Using the Commit Options to Commit Configuration Changes for details
about all commit options.
Click one:
2.
Add —Adds a scheduler map. Enter information into the scheduler map page as
described in Table 456 on page 3442.
—Modifies an existing scheduler map. Enter information into the scheduler map
Edit
page as described in Table 456 on page 3442.
—Deletes an existing scheduler map.
Delete
Your Action
To define a transmit rate, select the appropriate
option:
To enforce the exact transmission rate, select
Rate and enter a value.
To specify the remaining transmission
capacity, select Remainder Available.
To specify a percentage of transmission
capacity, select Percent and type an integer
from 1 through 100.
To specify no transmit rate, select the blank.
> Scheduler Maps .
Commit Options
Chapter 115: Configuring CoS
> . See
Commit
3441