Request Mpls Lsp Adjust-Autobandwidth - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos

request mpls lsp adjust-autobandwidth

Syntax
Syntax (EX Series
Switch)
Release Information
Description
Options
Additional Information
Required Privilege
Level
List of Sample Output
Output Fields
request mpls lsp request mpls lsp
adjust-auto-bandwidth adjust-auto-bandwidth
3746
®
OS for EX Series Ethernet Switches, Release 10.4
request mpls lsp adjust-autobandwidth
<logical-system (all | logical-system-name)>
<name lsp-name>
request mpls lsp adjust-autobandwidth
<name lsp-name>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.5 for EX Series switches.
Manually trigger a bandwidth allocation adjustment for active label-switched paths
(LSPs).
—Manually trigger a bandwidth allocation adjustment for all active LSP paths.
none
logical-system (all | logical-system-name)
systems or on a particular logical system.
—(Optional) Manually trigger a bandwidth allocation adjustment on the
name lsp-name
specified LSP only.
For this command to work properly, the following conditions must exist:
Automatic bandwidth allocation must be enabled on the LSP. The parameters for
adjustment interval and maximum average bandwidth are not reset after you issue
the request mpls lsp adjust-autobandwidth
The difference between the adjusted bandwidth and the current LSP path bandwidth
must be greater than the threshold limit.
maintenance
request mpls lsp adjust-auto-bandwidth on page 3746
When you enter this command, you are provided feedback on the status of your request.
user@host> request mpls lsp adjust-auto-bandwidth
—(Optional) Perform this operation on all logical
command.
Copyright © 2010, Juniper Networks, Inc.