Table 527: Port Mirroring Configuration Settings - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Table 527: Port Mirroring Configuration Settings

Field Function
Analyzer Name Specifies the name of the analyzer.
Ratio Specifies the ratio of packets to be mirrored. For example:
A ratio of 1 sends copies of all packets.
A ratio of 2047 sends copies of 1 out of every 2047 packets.
Loss Priority Specifies the loss priority of the mirrored packets.
By default, the switch applies a lower priority to mirrored data
than to regular port-to-port data—mirrored traffic is dropped
in preference to regular traffic when capacity is exceeded.
For port mirroring configurations with output to an analyzer
VLAN, set the loss priority to high.
Analyzer Port Specifies a local interface or VLAN to which mirrored packets
are sent.
NOTE: A VLAN must have only one associated interface to
be specified as an analyzer interface.
Ingress Specifies interfaces or VLANs for which entering traffic is
mirrored.
Egress Specifies interfaces for which exiting traffic is mirrored.
Copyright © 2010, Juniper Networks, Inc.
Add—Add an analyzer. Enter information as specified in Table 527 on page 3853.
Edit—Modify details of the selected analyzer. Enter information as specified in Table
527 on page 3853.
Delete—Delete the selected analyzer.
Enable/Disable—Enable or disable the selected analyzer (toggle).
NOTE: On EX2200, EX3200, EX4200, and EX4500 switches, only one
analyzer can be enabled at a time. On EX8200 switches, a maximum of seven
analyzers can be enabled.
NOTE: When an analyzer is deleted or disabled, any filter association is
removed.
Chapter 138: Port Mirroring
Your Action
Type a name for the analyzer.
Enter a number from 0 through 2047.
Keep the default of low, unless the output is
to a VLAN.
Click . In the Select Analyzer Port/VLAN
Select
window, select either port or VLAN as the
. Next, select the required port
Analyzer Type
or VLAN.
Click and select Port or VLAN. Next, select
Add
the interfaces or VLANs.
Click Remove to delete an ingress interface or
VLAN.
Click to add egress interfaces.
Add
Click Remove to remove egress interfaces.
3853