Table 40: Show Mpls L2Transport Interface Output Fields - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - POLICY MANAGEMENT CONFIGURATION GUIDE 2010-10-04 Configuration Manual

JunosE 11.3.x Policy Management Configuration Guide
Meaning
194
0 hcOctets, 0 errors, 0 discardPkts
queue 0: traffic class best-effort, bound to atm-vc ATM1/0.1
Queue length 0 bytes
Forwarded packets 0, bytes 0
Dropped committed packets 0, bytes 0
Dropped conformed packets 0, bytes 0
Dropped exceeded packets 0, bytes 0
MPLS policy input mplsInputPolicy
classifier-group claclWst50 entry 1
0 packets, 0 bytes
rate-limit-profile rlp
committed: 0 packets, 0 bytes, action: transmit
conformed: 0 packets, 0 bytes, action: transmit
exceeded: 0 packets, 0 bytes, action drop
MPLS policy output mplsOutputPolicy
classifier-group claclWst75 entry 1
0 packets, 0 bytes
rate-limit-profile rlp
committed: 0 packets, 0 bytes, action: transmit
conformed: 0 packets, 0 bytes, action: transmit
exceeded: 0 packets, 0 bytes, action: drop
Table 40 on page 194 lists the show mpls l2transport interface command output fields.

Table 40: show mpls l2transport interface Output Fields

Field Name
Interface
base-LSP/remote-addr
group-id
vc-id
mtu
state/in/out-label
Mpls Statistics
pkts
hcPkts
octets
hcOctets
Field Description
Specifier and status of each interface
Identifies either the tunnel that is selected to
forward the traffic or the address of the router
at the other end
Group ID number for the interface
VC ID number for the interface
Maximum transmission unit for the interface
Status of the Layer 2-over-MPLS connection or
the incoming/outgoing VC label
Number of packets received or sent
Number of high-capacity (64-bit) packets
received or sent
Number of octets received or sent
Number of high-capacity (64-bit) octets
received or sent
Copyright © 2010, Juniper Networks, Inc.