Configuring Ethernet Oam Connectivity Fault Management - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos
Meaning
Related
Documentation

Configuring Ethernet OAM Connectivity Fault Management

Configuring Ethernet OAM Connectivity Fault Management (CLI Procedure)
4082
®
OS for EX Series Ethernet Switches, Release 10.4
Cross-connect CCM received
RDI sent by some MEP
Statistics:
CCMs sent
CCMs received out of sequence
LBMs sent
Valid in-order LBRs received
Valid out-of-order LBRs received
LBRs received with corrupted data
LBRs sent
LTMs sent
LTMs received
LTRs sent
LTRs received
Sequence number of next LTM request
Remote MEP count: 2
Identifier MAC address
2001 00:90:69:0b:7f:71
When the output displays continuity-check status is
remote MEP, it means that connectivity fault management (CFM) has been configured
properly.
Understanding Ethernet OAM Connectivity Fault Management for an EX Series Switch
on page 4077
Junos OS Network Interfaces Configuration Guide
Configuring Ethernet OAM Connectivity Fault Management (CLI Procedure) on page 4082
Ethernet interfaces on Juniper Networks EX Series Ethernet Switches and Juniper Networks
Junos OS for EX Series switches support the IEEE 802.1ag standard for Operation,
Administration, and Management (OAM). The IEEE 802.1ag specification provides for
Ethernet connectivity fault management (CFM).
This topic describes these tasks:
Creating the Maintenance Domain on page 4083
1.
Configuring the Maintenance Domain MIP Half Function on page 4083
2.
Creating a Maintenance Association on page 4084
3.
4. Configuring the Continuity Check Protocol on page 4084
Configuring a Maintenance Association End Point on page 4084
5.
Configuring a Connectivity Fault Management Action Profile on page 4085
6.
Configuring the Linktrace Protocol on page 4086
7.
: no
: yes
: 76
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
: 0
State Interface
ok ge-0/2/5.0
enabled and displays details of the
Copyright © 2010, Juniper Networks, Inc.