Thresholds - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

thresholds

Syntax
Hierarchy Level
Release Information
Description
Options
Usage Guidelines
Required Privilege
Level
Copyright © 2010, Juniper Networks, Inc.
thresholds thresholds;
[edit services rpm probe owner test test-name]
Statement introduced before Junos OS Release 7.4.
Statement introduced in Junos OS Release 9.3 for EX Series switches.
Specify thresholds used for the probes. A system log message is generated when the
configured threshold is exceeded. Likewise, an SNMP trap (if configured) is generated
when a threshold is exceeded.
thresholds —Specify one or more threshold measurements. The following options are
supported:
—Measures maximum source-to-destination time per probe.
egress-time
—Measures maximum destination-to-source time per probe.
ingress-time
—Measures maximum source-to-destination jitter per test.
jitter-egress
—Measures maximum destination-to- source jitter per test.
jitter-ingress
—Measures maximum jitter per test, from 0 through 60,000,000 microseconds.
jitter-rtt
rtt —Measures maximum round-trip time per probe, in microseconds.
—Measures maximum source-to-destination standard deviation per
std-dev-egress
test.
std-dev-ingress —Measures maximum destination-to-source standard deviation per
test.
—Measures maximum standard deviation per test, in microseconds.
std-dev-rtt
successive-loss —Measures successive probe loss count, indicating probe failure.
—Measures total probe loss count indicating test failure, from 0 through 15.
total-loss
See Configuring RPM Probes.
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Chapter 141: Real-Time Performance Monitoring (RPM)
4027