Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 3787

Configuring the Primary Path
Copyright © 2010, Juniper Networks, Inc.
The primary statement creates the primary path, which is the LSP's preferred path. The
statement creates an alternative path if the primary path can no longer reach
secondary
the egress provider edge switch.
In the tasks described in this topic, the
ingress provider edge switch as
remote provider edge switch has already been configured as
When the software switches from the primary to the secondary path, it continuously
attempts to revert to the primary path, switching back to it when it is again reachable
but no sooner than the retry time specified in the
You can configure zero primary paths or one primary path. If you do not configure a primary
path, the first secondary path (if a secondary path has been configured) is selected as
the path. If you do not specify any named paths, or if the path that you specify is empty,
the software makes all routing decisions necessary for the packets to reach the egress
provider edge switch.
To configure a primary path:
Create the primary path for the LSP:
1.
[edit protocols mpls label-switched-path lsp_to_240 to 127.0.0.8]
user@switch# set primary primary_path_lsp_to_240
Configure an explicit route for the primary path by specifying the IP address of the
2.
loopback interface or the switch IP address or hostname of each switch used in the
MPLS tunnel. You can specify the link types as either
statement. If the link type is
the path statement without traversing other switches. If the link type is
can traverse through other switches before reaching this switch. This configuration
uses the default designation for the paths.
strict
NOTE: You can enable path protection without specifying which provider
switches are used. If you do not list the specific provider switches to be
used for the MPLS tunnel, the switch calculates the route.
TIP: Do not include the ingress provider edge switch in these statements.
List the IP address of the loopback interface or switch address or hostname
of all other switch hops in sequence, ending with the egress provider edge
switch.
[edit protocols mpls label-switched-path lsp_to_240 to 127.0.0.8]
user@switch# set path primary_path_lsp_to_240 127.0.0.2
user@switch# set path primary_path_lsp_to_240 127.0.0.3
user@switch# set path primary_path_lsp_to_240 127.0.0.8
lsp-name has already been configured on the
and the loopback interface address on the
lsp_to_240
revert-timer
strict
, the LSP must go to the next address specified in
strict
Chapter 134: Configuring MPLS
.
127.0.0.8
statement.
or in each
loose path
loose , the LSP
3683