Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 3886

Complete Software Guide for Junos
Table 514: show mpls lsp Output Fields (continued)
Field Name Field Description
Number of seconds remaining in the lifetime of the reservation.
Time left
Date and time when the RSVP session was initiated.
Since
Sender's traffic specification, which describes the sender's traffic parameters.
Tspec
Protocol ID and sender or receiver port used in this RSVP session.
Port number
Address of the previous-hop (upstream) routing device or client, interface the
PATH rcvfrom
neighbor used to reach this router, and number of packets received from the
upstream neighbor.
Address of the next-hop (downstream) routing device or client, interface used
PATH sentto
to reach this neighbor, and number of packets sent to the downstream routing
device.
RESV rcvfrom Address of the previous-hop (upstream) routing device or client, interface the
neighbor used to reach this routing device, and number of packets received
from the upstream neighbor. The output in this field, which is consistent with
that in the
Recorded route for the session, taken from the record route object.
Record route
Number of soft preemptions that occurred on a path and when the last soft
Soft preempt
preemption occurred. Only successful soft preemptions are counted (those
that actually resulted in a new path being used).
Soft preemption Path is in the process of being soft preempted. This display is removed once
the ingress router has calculated a new path.
pending
Default settings for MPLS traffic engineered LSPs:
MPLS-TE LSP
Defaults
LSP Holding Priority
session reservation after the LSP has been set up successfully.
LSP Setup Priority
LSP can be established.
Hop Limit
(including the ingress and egress).
Bandwidth
LSP Retry Timer
between attempts to establish the primary path.
show mpls lsp defaults show mpls lsp defaults
3782
®
OS for EX Series Ethernet Switches, Release 10.4
field, indicates that the RSVP negotiation is complete.
PATH rcvfrom
—Determines the degree to which an LSP holds on to its
—Determines whether a new LSP that preempts an existing
—Specifies the maximum number of routers the LSP can traverse
—Specifies the bandwidth in bits per second for the LSP.
—Length of time in seconds that the ingress router waits
user@host> show mpls lsp defaults
MPLS-TE LSP Defaults
LSP Holding Priority
LSP Setup Priority
Hop Limit
0
7
255
Copyright © 2010, Juniper Networks, Inc.
Level of Output
detail
detail
detail
detail
detail
detail
detail
detail
detail
detail
defaults