Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 4253

Additional Information
Copyright © 2010, Juniper Networks, Inc.
Chapter 146: Operational Commands for General Network Management and Monitoring
—(Optional) Display packet headers that match a regular expression.
matching matching
Use matching expressions to define the level of detail with which the
command filters and displays packet data.
no-domain-names —(Optional) Suppress the display of the domain portion of hostnames.
With the
no-domain-names
only team for the hostname
—(Optional) Do not put the interface into promiscuous mode.
no-promiscuous
no-resolve —(Optional) Suppress reverse lookup of the IP addresses.
—(Optional) Suppress timestamps on displayed packets.
no-timestamp
print-ascii —(Optional) Display each packet in ASCII format.
—(Optional) Display each packet, except the link-level header, in hexadecimal
print-hex
format.
resolve-timeout timeout —(Optional) Amount of time the router or switch waits for each
reverse lookup before timing out. You can set the timeout for between 1 and
4,294,967,295 seconds. The default is 4 seconds. To display each packet, use the
, , or
print-ascii print-hex
size size —(Optional) Read but not display up to the specified number of bytes for each
packet. When set to
brief
for capturing IP, ICMP, UDP, and TCP packet data. When set to
output, the default packet size is 1514. The
displayed packets if the matched data exceeds the configured size.
In the command, you can specify an expression to match by using the
monitor traffic
matching option and including the expression in quotation marks:
monitor traffic matching "expression"
Replace with one or more of the match conditions listed in Table 552 on
expression
page 4150.
option enabled, the
monitor traffic
team.company.net .
option.
extensive
output, the default packet size is 96 bytes and is adequate
monitor traffic
monitor traffic
command displays
and
detail extensive
command truncates
4149