Defining Cos Schedulers (J-Web Procedure) - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Related
Documentation

Defining CoS Schedulers (J-Web Procedure)

Copyright © 2010, Juniper Networks, Inc.
the scheduler map being used by the currently operating interfaces in a port group, the
default scheduler map is used by all interfaces in a port group, even the currently operating
ones, when you bring the interface up.
To change the scheduler map assigned to a port group:
Delete the current scheduler map from the interfaces (
1.
currently assigned to:
[edit class-of-service interfaces]
user@switch# delete xe-0/0/1 scheduler-map
[edit class-of-service interfaces]
user@switch# delete xe-0/0/2 scheduler-map
Assign the new scheduler map (
2.
[edit class-of-service interfaces]
user@switch# set xe-0/0/1 scheduler-map ef-map
Defining CoS Schedulers (J-Web Procedure) on page 3439
Example: Configuring CoS on EX Series Switches on page 3401
Assigning CoS Components to Interfaces (CLI Procedure) on page 3447
Monitoring CoS Scheduler Maps on page 3459
Understanding CoS Schedulers on page 3387
You can use the J-Web interface to define CoS schedulers on an EX Series switch. Using
schedulers, you can assign attributes to queues and thereby provide congestion control
for a particular class of traffic. These attributes include the amount of interface bandwidth,
memory buffer size, transmit rate, and schedule priority.
To configure schedulers:
Select >
1. Configure Class of Service
NOTE: After you make changes to the configuration in this page, you must
commit the changes immediately for them to take effect. To commit all
changes to the active configuration, select Commit Options > Commit.
See Using the Commit Options to Commit Configuration Changes for
details about all commit options.
Click one:
2.
Add —Adds a scheduler. Enter information into the schedulers page as described in
Table 455 on page 3440.
xe-0/0/1
ef-map ) to at least one interface in the port group:
> .
Schedulers
Chapter 115: Configuring CoS
and xe-0/0/2 ) it is
3439