Clear; Cli - Juniper MEDIA FLOW CONTROLLER 2.0.4 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Controller CLI Commands
Notes:
•
—Auto upload (when the set rotate criteria is reached) the cachelog using SCP
copy
(secure channel protocol), to the server specified using hostname. If username and
password are provided, Media Flow Controller uses that for authentication of the SCP
session. The no variant disallows auto upload. See
URL format); you must have an SCP server installed in order to SCP files to your
machine.
•
filename
cachelog.<num>.yyyymmdd_hour:min:sec (numbered sequentially).
•
on-the-hour
•
rotate
•
filesize-MB
"cache.log.1," "cache.log.2" and so on up to "cache.log.10," after which it wraps
around. By default, each file size is 100MB. We highly recommend not increasing the
size; huge file transfers take a lot of time, and if there is a system reset, large volumes
of data are at risk.
•
time-interval
cache log is rotated.
•
syslog replicate
part of SYSLOG; default is no (disabled), cache log is not seen as part of SYSLOG.

clear

clear arp-cache
EXEC command. Clear dynamic entries from the arp-cache.

cli

Configure CLI shell options.
cli
clear-history
default
auto-logout <length_in_minutes>
paging enable
prefix-modes enable
progress
prompt
show
session
auto-logout <length_in_minutes>
paging enable
296 clear
—Configure the name of the file where the cache log is stored. Default is
—Set hourly log rotation. Default is no (disabled).
—Media Flow Controller allows cache log rotation based on file size or time.
—Set rotation based on file size. Media Flow Controller creates
—Set rotation based on time. Specify a time in hours after which the
—Specify whether (enable) or not cache log messages are seen as
confirm-reload
confirm-reset
confirm-unsaved
empty-password
Media Flow Controller Administrator's Guide
"Terminology" on page 30
Copyright © 2010, Juniper Networks, Inc.
for the scp