Clear; Cli; Clock - Juniper MEDIA FLOW MANAGER 2.0.2 - ADMINISTRATOR S GUIDE AND CLI Administrator's Manual

Media Flow Manager Administrator's Guide
•
system
location ID. Use next to set the boot location to be the next one after the one currently
booted from. Note this does not mean the next one after the one Media Flow Controller is
currently set to boot from; thus the command is idempotent, and does not cycle through all
of the available locations.
show bootvar
Similar to show images in that it displays what images are on the two locations, and which
are the active and default location; but not all of the show images data is displayed.

clear

clear arp-cache
EXEC command. Clear dynamic entries from the arp-cache.

cli

Configure CLI shell options. See

clock

Set the system clock and timezone.
clock
set <hh>:<mm>:<ss> [<yyyy>/<mm>/<dd>]
timezone <zone> [<zone_word>] [<zone_word>] ...
Notes:
•
—Set the system clock. The time must be specified. The date is optional; if not
set
specified, the date is left the same.
•
timezone
The timezone may be specified in one of three ways:
• A nearby city whose timezone rules follow. The system has a large list of cities that
can be displayed by the help and completion system. They are organized
hierarchically because there are too many of them to display in a flat list. A given city
may be required to be specified in two, three, or four words, depending on the city.
The possible forms this could take include:
• An offset from GMT. This is in the form:
• UTC. This is almost identical to GMT.
—Specify which location the system should boot from by default; use 1 or 2 for
"CLI Options" on page 96"
—Set the system time zone. Default is UTC. The no variant resets to default.
<continent> <city>
<continent> <country> <city>
<continent> <region> <country> <city>
<ocean> <island>
(default)
GMT-offset GMT
GMT-offset GMT+<1-12>
GMT-offset GMT-<1-14>
CHAPTER 5 CLI Commands
for details.
clear 103