Configure a Label Switched Path (LSP) to Use in Dynamic MPLS
Copyright © 2010, Juniper Networks, Inc.
Configuring Label Switched Path (NSM Procedure) on page 287
Configuring Label Switched Path (NSM Procedure)
You can configure a label switched path (LSP) to use in dynamic MPLS.
To configure a LSP in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Label Switched Path.
4.
Add or modify settings as specified in Table 148 on page 288.
5.
Click one:
6.
OK-Saves the changes.
Cancel-Cancels the modifications.
Chapter 20: Configuring Protocols
287