Measuring Principles - ABB Relion 670 Series Technical Reference Manual

Section 6
Impedance protection
6.2.2.4
202

Measuring principles

Fault loop equations use the complex values of voltage, current, and changes in the
current. Apparent impedances are calculated and compared with the set limits. The
calculation of the apparent impedances at ph-ph faults follows equation
for a phase A to phase B fault).
V - V
A B
=
Z
app
I - I
A B
EQUATION1545 V1 EN
Here V and I represent the corresponding voltage and current phasors in the respective
phase.
The ground return compensation applies in a conventional manner to ph-g faults
(example for a phase A to ground fault) according to equation 15.
V _ A
=
Z
app
+ ×
I _ A I KN
N
EQUATION1546 V1 EN
Where:
V_A, I_A and IN are the phase voltage, phase current and residual current present to the IED
KN is defined as:
-
Z0 Z1
=
KN
×
3 Z1
EQUATION-2105 V1 EN
= +
Z 0 R 0 jX 0
EQUATION2106 V1 EN
= +
Z 1 R 1 jX 1
EQUATION2107 V1 EN
Where
R0 is setting of the resistive zero sequence reach
X0 is setting of the reactive zero sequence reach
R1 is setting of the resistive positive sequence reach
X1 is setting of the reactive positive sequence reach
1MRK505222-UUS C
14 (example
(Equation 14)
(Equation 15)
Technical reference manual